Brennan, Robert WilliamLyu, Guolin2023-07-242023-07-242023-07-21Lyu, G. (2023). Multi-agent modelling of industrial cyber-physical systems for IEC 61499 based distributed intelligent automation (Doctoral thesis, University of Calgary, Calgary, Canada). Retrieved from https://prism.ucalgary.ca.https://hdl.handle.net/1880/116791https://dx.doi.org/10.11575/PRISM/41633Traditional industrial automation systems developed under IEC 61131-3 in centralized architectures are statically programmed with determined procedures to perform predefined tasks in structured environments. Major challenges are that these systems designed under traditional engineering techniques and running on legacy automation platforms are unable to automatically discover alternative solutions, flexibly coordinate reconfigurable modules, and actively deploy corresponding functions, to quickly respond to frequent changes and intelligently adapt to evolving requirements in dynamic environments. The core objective of this research is to explore the design of multi-layer automation architectures to enable real-time adaptation at the device level and run-time intelligence throughout the whole system under a well-integrated modelling framework. Central to this goal is the research on the integration of multi-agent modelling and IEC 61499 function block modelling to form a new automation infrastructure for industrial cyber-physical systems. Multi-agent modelling uses autonomous and cooperative agents to achieve run-time intelligence in system design and module reconfiguration. IEC 61499 function block modelling applies object-oriented and event-driven function blocks to realize real-time adaption of automation logic and control algorithms. In this thesis, the design focuses on a two-layer self-manageable architecture modelling: a) the high-level cyber module designed as multi-agent computing model consisting of Monitoring Agent, Analysis Agent, Self-Learning Agent, Planning Agent, Execution Agent, and Knowledge Agent; and b) the low-level physical module designed as agent-embedded IEC 61499 function block model with Self-Manageable Service Execution Agent, Self-Configuration Agent, Self-Healing Agent, Self-Optimization Agent, and Self-Protection Agent. The design results in a new computing module for high-level multi-agent based automation architectures and a new design pattern for low-level function block modelled control solutions. The architecture modelling framework is demonstrated through various tests on the multi-agent simulation model developed in the agent modelling environment NetLogo and the experimental testbed designed on the Jetson Nano and Raspberry Pi platforms. The performance evaluation of regular execution time and adaptation time in two typical conditions for systems designed under three different architectures are also analyzed. The results demonstrate the ability of the proposed architecture to respond to major challenges in Industry 4.0.enUniversity of Calgary graduate students retain copyright ownership and moral rights for their thesis. You may use this material in any way that is permitted by the Copyright Act or through licensing that has been assigned to the document. For uses that are not allowable under copyright legislation or licensing, you are required to seek permission.Industrial Cyber-Physical SystemsDistributed Intelligent AutomationIEC 61499 Function Block ModellingMulti-Agent ModellingAutonomic ComputingEngineering--System ScienceEngineering--IndustrialEngineering--Mechanicaldoctoral thesis